KYMCO Super 8 50, Service Manual

Page: 181 / 185

17
. LIGHTS/INSTRUMENTS/SWITCHES
17-1
Super 8 50
FUEL UNIT
REMOVAL
Remove the met-in box. (

2-3)
Remove the frame right side cover. (

2-4)
Disconnect the fuel unit wire connector.
Turn the fuel unit retainer counterclockwise
to remove it.
Remove the fuel unit.
INSTALLATION
The installation sequence is the reverse of
removal.
INSPECTION
Remove the fuel unit.
Measure the resistance between the fuel unit
wire terminals with the float at upper and
lower positions.
Wire Terminals Upper Lower
G
～
Y/W 30

686

G
～
L/W 566

153

Y/W
～
L/W 599

599

FUEL GAUGE INSPECTION
Connect the fuel unit wire connector and turn
the ignition switch “ON”.
Check the fuel gauge needle for correct
indication by moving the fuel unit float up
and down.
Float Position Needle Position
Upper
“F” (Full)
Lower
“E” (Empty)
No Smoking!
＊
Be careful not to bend or damage the
fuel unit float arm.
＊
AC 110V
Do not damage the fuel unit wire.
＊

Align the groove on the fuel unit with
the tab on the fuel tank.

Align the arrow on the retainer with the
arrow on the fuel tank.

Turn the retainer clockwise to secure it.
＊
Before performing the following test,
operate the turn signals to determine that
the battery circuit is normal.
＊
Fuel Unit
G
L/W
Y/W
Fuel Unit
Tab
Groove