KYLAND Technology KIEN3016M, User Manual

Page: 36 / 80

KIEN3016M/3024M Industrial Ethernet Switch User’s Manual
-26-
6.3
Testing Fiber Ports
Let the equipment of KIEN3016M.3024M at both ends to form a fiber link network as
shown in Fig. 6-2., connect any one Ethernet interface of each equipment to the
testing computer by straight-through network cable, transmit Ping command mutually,
both sides can correctly Ping to each other and no data package is lost. At the same time,
DPX light is always on and the LINK blinks. This indicates the tested hardware of the
two electrical operates normally. The same testing method will be used to test the other
pair of optical ports (For detailed operation of the Ping command, please refer to the
following examples).
14
13 1 3 5
2 4 6
7 9 11
8 10 12
15
16
AT AR BT BR CR CT DT
CONSOLE
DR ON
OFF
AC220V
DC POWER
POWER
14
13 1 3 5
2 4 6
7 9 11
8 10 12
15
16
AT AR BT BR CR CT DT
CONSOLE
DR ON
OFF
AC220V
DC POWER
POWER
测试计算机1
测试计算机2
KI EN3016M或KI EN3024M工业以太网交换机
Figure 6-2 Testing Fiber Ports
PING Command
The IP address of the testing computer 1 is 192.168.100.10 and the 2 is
192.168.100.11.On the testing computer 1, run “cmd” in the WIN2000 operating
system or “command” in the WIN98/95 operating system from “Run” in the “Start”
menu. Send “ping 192.168.100.11 –l 1000 –t”. (-1 means byte number of the sent data
package; -t means continuously sending data). On the testing computer 2, run “cmd” in
the WIN2000 operating system or “command” in the WIN98/95 operating system from
“Run” in the “Start” menu. Send “ping 192.168.100.10 –l 1000 –t”. If switches run
normally, the testing computer 1 returns “Reply from 192.168.100.11
：
bytes=1000
time<10ms TTL=128” and the 2 returns “Reply from 192.168.100.10
：
bytes=1000
time<10ms TTL=128”, and the counted package loss rate is zero checked by the
CTL+C command ten minutes after running
KIEN3016M or KIEN3024M Industrial Ethernet Switch
Testing Computer 1
Testing Computer 2
Testing Computer 1