KYLAND Technology KIEN3016M, User Manual

Page: 27 / 80

Chapter Four KIEN3024M Hardware Structure
-17-
Blinking active network
OFF connection fault
4.2.3
Rear Panel
There are totally 2 pair of fiber ports and 24 RJ45 ports, 1 DC/AC power terminal at
the rear panel shown in Figure 4-4:
RJ45端口
光接口
1
5
交流电源输入端 直流电源输入端
2
6
3 4
7 8
9 10
13 14
11
15
DC POWER
12
16
交流电源开关
POWER
AC220V
OFF
ON
CONSOLE
RS232控制台端口
17 19 21 23
18 20 22 24
BT BR AR AT
Figure 4-4 Rear Panel
Fiber Port ：
KIEN3024M offers 2 slots for fiber ports as A,B and is custom-made for 0 to 2
fiber ports of 100Base-FX. The connector is SC. The fiber ports must be used in
pair. xT is for transmitting and is connected to remote xR port. xR is for receiving
and is connected to XT port.(X means A,B).
Ethernet Port ：
KIEN3024M offers 24 RJ45 ports of 10Base-T/100Base-TX. Each port is
adaptive and supports for auto MDI/MDI-X connection. You can connect it to
terminal device, server, hub or switches by straight-through or cross-over cables.
Each port supports for IEEE802.3x and is adaptive to half/full-duplex or 10 or
100Mbps. If the connected devices don’t support such feature, the port will
transmit the correct rate.
RS232 （ CONSOLE ）
The RS232 console port is a shielded RJ45 connector, the standard is 3-wire
RS232, you can connect. You can use a serial cable with one end RJ45 and
another end DB9F to connect the RJ232 console port with the 9-pin serial port of
the PC. You can run the hyper terminal software of WINDOWS system to
configure and manage the switch.
CONSOLE port ： Baud rate ： 9600 ， data ： 8 ， check ： no ， stop ： 1 traffic control ：
no 。
Optic Fiber Port RJ45 Port DC Power AC Power
AC Power Switch RS232 Control Port