KYLAND Technology KIEN3016M, User Manual

Page: 33 / 80

Chapter Five Hardware Mounting
-23-
5.4
Optical fiber connection
KIEN3016M/KIEN3024 provides 0 ～ 4 or 0 ～ 2 pair of ports of 100Base-FX full
duplex single mode or multi-mode optical fiber interfaces. These optical fiber
interfaces can be used to realize the uplink connection between switches. SC connector
is required.
Warning:
This switch uses laser to transmit signal on optical fiber cable. The laser meets class 1
laser product requirements and harmless to eyes under normal operation. However,
when the equipment is switched on, do not stare directly into the optical fiber
transmitting interface and the end of optical fiber terminator.
Connect pluggable optical fiber module according to the following procedures:
1
．
Remove and keep the rubber sleeve of SC port. When it is not in use, cover SC
port with the rubber sleeve to protect the optical fiber terminator.
2 ． Check whether the optical fiber terminator is clean. Slightly wet a clean tissue or
cotton ball and carefully wipe cable plugs. Contaminated If the optical fiber
terminator is contaminated, transmitting quality of optical fiber will reduce,
affecting port performances.
3 ． Connect one end of optical fiber cable to the optical fiber interface of the switch
and the other end to the optical port of another equipment.
5.5
Cable Wiring
Cable wiring should meet the following requirements:
1
．
Before cable wiring, check whether the specifications, models and quantities of
all cables comply with the construction drawing design and contract
requirements.
2 ． Before cable wiring, it is necessary to check whether there is damaged cable and
whether the cables are accompanied by ex-factory records and vouchers attesting
their quality such as quality assurance certificate etc.