KYLAND Technology KIEN3016M, User Manual

Page: 21 / 80

Chapter Three KIEN3016M Hardware Structure
-11-
ON correct connection
Blinking active network
LINK
OFF connection fault
Ethernet Port 1-16
ON
100M
）
10M/100M
OFF 10M
ON correct connection
Blinking active network LINK/ACT
OFF connection fault
3.2.3
Rear Panel
There are totally 4 pair of fiber ports and 16 RJ45 port, 1 DC/AC power terminal at the
rear panel shown in Figure 3-4:
RJ45端口
光接口
1
5
交流电源输入端
直流电源输入端
2
6
3 4
7 8
9 10
13 14
11
15
DC POWER
12
16
交流电源开关
POWER
AC220V
OFF
ON
CONSOLE
RS232控制台端口
AR AT BR BT CR CT DR DT
Figure 3-4 Rear Panel
Fiber Port ：
KIEN3016M offers 4 slots for fiber ports as A,B,C,D and is custom-made for 0 to
4 fiber ports of 100Base-FX. The connector is SC. The fiber ports must be used in
pair. xT is for transmitting and is connected to remote xR port. xR is for receiving
and is connected to XT port.(X means A,B).
Ethernet Port ：
KIEN3016M offers 16 RJ45 ports of 10Base-T/100Base-TX. Each port is
adaptive and supports for auto MDI/MDI-X connection. You can connect it to
terminal device, server, hub or switches by straight-through or cross-over cables.
Each port supports for IEEE802.3x and is adaptive to half/full-duplex or 10 or
100Mbps. If the connected devices don’t support such feature, the port will
transmit the correct rate.
RS232 （ CONSOLE ）
The RS232 console port is a shielded RJ45 connector, the standard is 3-wire
Optic Fiber Port RJ45 Port DC Power AC Power
AC Power Switch RS2 32 control port