Kwik Lok 086B-100, Instruction Manual

Page: 16 / 72

SECTION III
Adjustments
P 3.2
B. TOP CLOSURE TRACK REMOVAL:
Figure 3.1
The top of the closure track can be removed
from the closer while the closure track assembly
remains attached to the closer mainframe. This can
be done to expose the slot that the closures move
through. The closure track can be inspected and
cleaned if needed.
1. Disconnect the 0S-006 spring from the ink roll
arm of the printer assembly (Printer Model only).
2. Remove the flat head screws from the track.
Note the different screw lengths upon
removal.
3. Remove the top track from the remaining lok
track assembly.
C. REMOVE THE FRONT SHIELD:
Some of the adjustments described in this section
require removal of the front shield.
DISCONNECT POWER
1. Remove the side access cover from the closer
frame.
2. Remove the two self tapping phillips screws
used to fasten the sides of the shield to the
closer frame
3. Loosen (turn clockwise) the two shield mounting
screws on the underside of the closer frame.
4. Press lightly from the inside of the closer frame
on the backside of the shield to remove it.
086B 02 18
086B Stop mount
position (Models 200,
600, 700)
Stop mount screws (2)
Closure stop
tip centered
086B Stop mount
position (Model 100)
Figure 3.3
CHECK AND CLOSURE
STOP (Model 100)
CHECK AND CLOSURE STOP
(Models 200, 600, 700)
Check
Stop mount
Check
Check mounting
position (Models 200,
600, 700)
Check mounting
position (Model 100)
Check mounting
position (Model 100)
Check mounting
position (Models 200,
600, 700)