SECTION II
Operation
P 2.6
CLOSURE TO SERIES CR CLOSURE - LABEL
CONVERSION:
1. Remove the two M5 screws securing the two lok
guide shims. There are two threaded holes in
the closer stand to keep unused M5 screws.
2. Remove both shims (Figure 2.8 Shim Position
Series CR and U Closure - Label) and hang
them on the studs located inside of the closer
stand.
3. Remove the two frame spacer mounting screws
and remove the spacer from between the two
roll supports.
4. Remove the four screws securing the two roll
supports to the closer.
5. Fasten the CR closure - label spacer between
the two roll supports with the two M5 screws that
were used for the previous spacer.
6. Align the mounting holes of the roll supports to
the appropriate threaded holes on the closer
(Figure 2.7).
7. Fasten the two roll supports to the closer using
the four M5 screws that were removed earlier.
8. Insert the CR closure - label hub into a roll of CR
series closure - labels and place them in label
side up.
9. Insert the end of the closure - label strip, label
side up, into the closure track. Feed the strip
into the track until the strip engages the closure
stop.
086B 02 18
Shim position (1 Shim)
Series L Closure - Label
Shim position (No shims)
Series CR and U Closure - Label
Shim position (2 Shims)
Series R, S, RL, and SL shim position
00-001564 Shim -
right lok guide
00-001584 Shim -
left lok guide
Shim mounting
screws
Figure 2.8
Lok track shim position
Summary of Contents for 086B-100
