2-6
A Guide to TracVision Cruiser
12. For each hole, place a
1
⁄
4
" flat washer on a
3"
1
⁄
4
-20 bolt (from the kit pack) and place it into
the mounting hole from above.
13. Apply a flat washer, lock washer, and nut (the
ones removed in step 3) to each mounting bolt
from below decks and tighten securely. The
correct mounting arrangement is illustrated in
Figure 2-7.
2.4 Connecting the Antenna Unit
The following sections provide instructions for properly wiring
the Antenna Unit to the IRD and to vessel power.
Tips for Safe and Successful Wiring within
the TracVision Cruiser Baseplate
•
When attaching cables to the TracVision Cruiser
terminal connector strips, make sure the
insulation is stripped back approximately
1
⁄
4
˝
.
Twist the wires gently to help achieve a good
connection. Do not pinch insulation inside the
connector.
•
After attaching the power and data cables to the
appropriate terminal connector strips, tug gently
to ensure a firm connection.
Figure 2-8
Proper Wire-to-Terminal
Connection
Insulation
Terminal Connector
1/4
˝
Figure 2-7
Bolting TracVision Cruiser
to the Deck (Side View)
Bolt
Flat Washer
Stiffening Plate
Deck
Flat Washer
Hex Nut
Silicone
Lock Washer
TracVision Cruiser
Baseplate
Silicone