2-11
Installation
54-0144 Rev. C
2.4.3 Connecting the Antenna RF Signal
Cable to the IRD
The RF signal cable is fitted with an F-type connector at only
one end and should be attached to TracVision Cruiser and the
IRD as follows:
1. Feed the bare end of the RF signal cable
through the #2 liquid-tight fitting (refer to
Figure 2-10) at the back of the TracVision Cruiser
baseplate and away from the dome, leaving the
F-connector inside the TracVision Cruiser
baseplate (as pictured in Figure 2-18).
Figure 2-17
Wiring TracVision Cruiser
to Vessel Power
+12v DC
Rocker
Switch
+12v DC
Ground
Shield
+12v DC
Ground
Shield
Splice
When wiring the rocker switch, it is
recommended that the shield wire
from the TracVision Cruiser be
connected to the shield from vessel
power.
Figure 2-18
Connecting the RF Cable to
TracVision Cruiser
Entry Port for
RF2 Connector
RF2
To Vessel