2-12
A Guide to TracVision Cruiser
2. For single IRD installation, connect the RF signal
cable’s F-connector to the plug labeled RF2.
3. Feed the bare end of the RF signal cable and
pass through the cable hole drilled earlier and
into the vessel.
4. Attach the provided F-connector to the end of
the RF signal cable inside the vessel as
illustrated in Figure 2-19a-d, using an Augat
Snap ‘n Seal Crimp/Strip tool to lock the
connector on the cable.
A. Slide compression fitting onto raw cable
before beginning connector termination.
B. Twist and break off connector body.
C. Use Augat tool to strip center conductor to
and trim back overall jacket. Do not cut
through braid.
D. Slide connector body onto the prepared
cable. Slide the compression fitting up into
the connector body. Use Augat tool to snap
on the connector.
5. Attach the cable to the IRD connector labeled
SATELLITE IN.
Figure 2-19a-d
Attaching the Provided
F-connector to an RF Cable
Twist
KVH has provided an F-connector
for use with the TracVision Cruiser.
This connector specifically requires
the Augat Snap
‘
n Seal Crimp/Strip
Tool, part number IT1000.
If you do not have this tool, you will
need to purchase a silicone-filled,
weatherproof F-connector (Radio
Shack Part Number 278-236 or
equivalent) to use instead.
0.25
0.25
