Kverneland H Series, Technical & Service Manual, Page: 21 / 52

21
1. Assembly
21
• Tools :
Pipe, hammer, snap ring pliers,
Torquemeter, adjustable wrench, chisel.
NOTES
• Clean all the components from remaining grease and silicone.
• Replace any particular damaged.
• When assembling the taper roller bearings, pay attention to not
make any pressure on the cages in order to avoid any damage.
• When assembling oil seals avoid contact with cutting parts
in order to prevent any damage to the inner lip.
• Insert oil seals taking care or greasing the zone of contact
between oil seal and shaft.
• Assemble outer ring (5) inside the housing
• Insert the inner ring (5).
• Assemble inside housing: Spacer (65),
gear(31), spacer(20),gear (17),spacer(16),
shim (1),gear (7)
• Assemble shaft (29) paying attention to fit
all components previously assembled
.
• Assemble: spacer (2) and inner ring (5).
• Assemble: outer ring (5) and snap ring (3)
• Set the shaft (29) by hitting from both sides
• Check the axis preload ( K ),use torquemeter
• Disassemble snap ring (3).
• Assemble shims (6) and snap ring (3).
• Set the shaft(29) by hitting from both sides
• Check the axis preload ( W ),use torquemeter
• The difference between, value (W) and (K)
the axis preload that must be to 0÷3 kgcm.
If the value is not correct change shims (6) setting.
• Assemble: spring(50),spacer (63), piston 53)
and snap ring (52).
• Assemble spacer(63),piston(53),snap ring(52)
• Assemble shim(13),snap ring(8),inner ring(12)
• Put a Loctite 270 film on locknut (11) threads
• Assemble locknut (11) and tighten manually
in order to fix the taper roller bearing (12).
• Caulk the locknut.