Kverneland H Series, Technical & Service Manual, Page: 12 / 52

12
General data and equipment
0°
Construction
12
Timing process:
1. Remove all tine carriers.
2. Assemble one central tine carrier and rotate it so that the tines are in-line
with the axis of the trough (reference rotor).
3. Assemble the two adjacent tine carriers with a phase angle of b5° and +15°.
Procedure: position the tine carrier at 90° to the reference tine carrier and rotate it until you find the
first
possible assembly position. The phase angle must not exceed 15° . If it is not possible to find a
position between 5° and 15° rotate the tine carrier 180° and try again. NB The alignment of three adjacent
tine carriers must be convergent (or divergent), not parallel. (Fig.1)
4. Rotate the newly assembled tine carrier so that it is in-line with the trough (as in step 2)
5. Assemble the next adjacent tine carrier so that the phase angle is between -5° and -15° (as in step 3
but in the opposite direction). (Fig.2)
6. Proceed in this way for all remaining tine carriers
.
-75° 75° 30° 45° 60°
-30° -45 -60 -15
Resetting operation of tine carriers’ ” TIMING”,