About the Entering Data into the Setup Screens
KVAL 990-H Operation Manual
2-40
About the Entering Data into the Setup Screens
Select the
Calibration
Button to open access to the
Main Cal
,
Setup Hinge 1-3
screen, and the
Pre-
Drill Setup
screen. The Calibration Tab contains access to screens to adjust servo motors in the
machine.These software routines are designed to fine tune the servos for optimum accuracy by
entering offsets and storing the data entered.
•
Main Cal:
Fine tune main assemblies on the front and back section
•
Setup Hinge 1-3:
Fine tune the Setup Hinge positions and the positions of each
assembly located in the carriages.
•
Pre-Drill Setup:
Set-up and store pre-drill patterns.
How to Enter Calibration Data
Adjustment menus are located in the setup screens. In these menus, you can add negative or posi-
tive adjustments to move a servo to desired positions to compensate (tune) for any deviation’s
from the expected cut. The calibration can then be stored.
Below are general instructions to perform a calibration.
1.
Check for deviations in the expected machining and actual machining. Measure the
offset from the expected result. Use this number to enter into the offset box under
the inaccurate parameter.
2.
Enter the offset positive or negative number in the
white box below the
Offset
title to adjust the servos
in the X, Y, and Z directions.
3.
The
Base
display box keeps a running total of data
entered to help keep track of the changes.
4.
The
Combine
button merges the offset number to
the base to adjust the servo.
5.
Run a test door again to verify the offset correction was successful.
6.
Keep running a test door and adjusting the offset until satisfied with the result
7.
After satisfied, click the
Save
button to store the calibration.
Note:
If more than 0.50 inches of adjustment is needed, there is a high probability that
another issue may be causing a problem. Perform a visual check of the assembly to
be calibrated and check the
Diagnostic Screen
for error reporting. Finding errors
from these screens will help localize problem areas.
Summary of Contents for 990-H
