Kval 990-H, Operation Manual

Page: 58 / 88

Summary of the Interface
2-29
KVAL 990-H Operation Manual
Summary of the Interface
The software includes a single
User Interface
to control the entire machine. The interface uses side
“jump buttons” to navigate the software.
Machine Control and Calibration Screens
Below are screen shots of the operator screens that control the machine.
The
Main Screen
is also the startup screen for the
990-H. From this screen, all the basic user inter-
face controls are available to run a door.
See “Main Screen” on page 2-32.
Main Control
Manual Servo Control
From the
Manual
Screen you can control certain
functions of the machine in manual mode. From
this menu branch, select to assemblies to move
“jog” manually.
See “Manual Operation” on page 2-36.
Setup
The
Setup Screens
address calibrations of the
servo driven assemblies.
See “Setup Screen” on page 2-42.
See “Setup Hinges 1-3 Screens” on page 2-45.
See “About the Pre-Drill Screen” on page 2-49.