About the Six Shooter System
2-11
KVAL 990-H Operation Manual
About the Six Shooter System
There are three Six Shooters on the front section. The Six Shooters attach the hinge to the hinge
pockets and then secures them with six screws on the jamb and the door.
Valve Bank:
Controls air
delivery to the air cylin-
ders of the six shooter.
Hopper Screw Tracking
Plate:
Contains the screws
and delivers them to the Screw
Receive by way of the
Screw
Delivery System.
Screw Driver Assembly:
Contains air motor, gear-
box, screw drivers to
attach all 6 screws to
hinge to jamb and the door
Screw Delivery System:
Six tubes that deliver the
screws to the screw
receiver for application to
the jamb and door
About the Hopper
See the figure below for identification of Hopper assemblies. See “Hopper Process” on page
for operation descriptions.
Important:
Do not put Magnetized Screws in Hopper. Magnetized
screws can cause sluggish response to screws getting
stuck. Hopper plates could get magnetized and will have
to be demagnetized with a degausser.
Important:
Do not adjust any of the Hopper air cylinders. They are adjusted at the
factory. Any adjustment may cause timing issues with the operation of
the Six Shooter. If you think problems are being caused by the cylinders,
please contact the KVAL Service Department for direction.
Important:
Do not mix screw types in the Hopper. Different sizes, pitches can cause
uneven application of the hinge.
Summary of Contents for 990-H
