Kval 979-2, Operation And Service Manual

Page: 37 / 112

Quick Start
2-12
KVAL 979-2 Operation/Service Manual
Quick Start
Note:
Before starting production, it is recommended to perform a test cut on a board.
Follow the same steps in the Quick Start below. See “Running a Reference Cut” on
page 2-27
1.
Ensure factory air is present at the machine and the 979-2 main air
supply valve is turned on.
2.
Power up the 979-2. See “How to Power Up the 979-2” on page 2-
14.
3.
Home the 979-2. See “Home the 979-2” on page 2-15.
4.
Set the machine up for the chosen parameters. See “Mechanical Set
Up” on page 2-18
5.
Select the cut mode.
6.
Select the desired preset button.
7.
Select quantity of boards to cut. Enter the cut
length if different than the pre-set.
8.
Select type of cut.
Note:
KVAL strongly recommends using
the
Wide Jamb
selection on cuts.
This setting makes good cuts with
maximum efficiency.
9.
Select the
Load the Cut Parameters
Button. The
parameters will be displayed in the box.
Preset Buttons