66
SENSe:
TCOuple:RJUNcion:SIMulated {<
value
>|MINimum|MAXimum}
SENSe:
TCOuple:RJUNcion:REAL:OFFSet {<
value
>|MINimum|MAXimum}
4.1.9 Remote Interface Selection
The multimeter supports both GPIB and USB interfaces, but only one
interface can be activated at a time. If you are using GPIB, you must set
the address for the multimeter. You can set the address to any value
from 0 and 31. The address is set to “11” when the multimeter is shipped
from the factory.
※
Note: The remote interface can only be set through the front panel
operations.
How to select a remote interface
Press MENU and then use
◁
and
▷
to select INTERFACE. Then Press
ENTER on your choice of USB or GPIB interface.
How to set address when using GPIB
Press MENU and then use
◁
and
▷
to access INTERFACE. Select GPIB
to set address. Use
◁ ,
▷ ,
△
and
▽
to adjust the numbers to the
desired address. Press ENTER to set it.
4.1.10 Input Terminal Switch
Definition
User can select either the front input terminals or the rear input
terminals for their measurements. There are 5 input terminals in the
front panel as well as the rear panel. If the rear terminal is enabled the
REAR annunciator at the upper side will be shown.
Default
The default situation is the front terminals.
Summary of Contents for M3500A
