Kusam-meco M3500A, Operation Manual, Page: 101 / 158

101
ENTER to select it. The message about error queue will show on the
display. Refer to Chapter 6 for the descriptions of all the error
messages. The locations of the buttons are shown with red rectangle
frames in
Figure 4-35 .
Figure 4-35
4.4.10 Firmware Revision
M3500A has three microprocessors for various internal systems. You can
query the multimeter to determine which revision of firmware is installed
for each microprocessor.
How to check the firmware revision
Press MENU and then use
◁
and
▷
to locate “SYSTEM” submenu. Press
ENTER to select it. Again use
◁
and
▷
to locate “REVISION
”
option.
Press ENTER to select it. The multimeter gives three numbers in
xx-xx-xx format on the display. The first number is the firmware revision
number for the measurement microprocessor; the second number is for
I/O processor and the third number is for the front-panel processor.
The
locations of the buttons are shown with red rectangle frames in Figure
4-36 .