DO0281R00
35 / 58
Configuring TAP CURIOUS
◦ Click on "Config settings > Show settings".
Device information
Device information is displayed in the first line:
– Serial number of TAP CURIOUS
– Software version
– MAC address
These data are specified by KUNBUS for this device and cannot be changed.
Please have these data to hand if you report a problem to our support.
Connection settings
You can select the connection speed for all ports in the "Channel mode" menu. The
default speed is 100 Mbit.
◦ To change the default, check the "10 Mbit mode" box.
DHCP settings
If you use a DHCP server, it can assign a free IP address to TAP CURIOUS.
◦ In the "Use DHCP" menu, click on "Yes" to use DHCP.
Configuration
You can change the following communication parameters in the "Config TAP"
menu:
– IP address
The IP address ensures that TAP CURIOUS can be clearly identified within a
network. When assigning a new IP address, you should therefore make sure
that it is not being used by another device in the network.
If you use DHCP, you do not need to set the IP address. In this case, TAP
CURIOUS will receive the IP address from the DHCP server.
– Subnet
This is where you can adapt the net mask. The net mask is a bit mask that
indicates the bit position within the IP address that is being used to address the
network section. Make sure the settings you change here match your network
settings.
– Gateway address
You can set the gateway address here.
Filters
