DO0281R00
24 / 58
To use any filter setting, you need to have activated the filter and saved the
settings. Do this by clicking on "On" and then "Save".
You can set the following filters:
Dest. address filter
This is where you can set frames that are transmitted to a particular MAC address.
Enter the MAC address you require.
Check the "Set filter > Negate" box to filter all frames that are not transmitted to this
MAC address.
You can combine the filter with the external input. Do this by checking the "External
input > Yes/No" box.
Check the "External input > Negate" box if the external input has to be "low".
Src. address filter
This is where you can set frames that are transmitted from a particular MAC
address. Enter the MAC address you require.
Check the "Set filter > Negate" box to filter all frames that are not transmitted from
this MAC address.
You can combine the filter with the external input. Do this by checking the "External
input > Yes/No" box.
Check the "External input > Negate" box if the external input has to be "low".
Ethernet type
This is where you can filter by the protocol type via which a frame's useful data are
transmitted. The values comply with the Ethernet specification.
We have gathered the values of a few important protocols for you here:
Type
Protocol
0x0800
IP Internet Protocol, Version 4 (IPv4)
0x0804
Address Resolution Protocol (ARP)
0x8100
VLAN Tag
0x8892
PROFINET
0x884A
EtherCAT
0x88AB
POWERLINK
0x88CD
SERCOS III
Filters
