Kühtreiber MAKin 400 S, Instructions For Use Manual

Page: 23 / 36

| 23 en
pulse double pulse manual
N-coder ii material thickness
synergic
pulse double pulse manual
N-coder ii Wire feed speed
synergic
Mig/MAg - Setting the PRe-gAS function
the function serves to provide a protective atmosphere before the arc is ig -
nited. pressing the control button on the burner activates the function that is
active for the set time. after the set time has elapsed, the welding arc ignites.
to activate, press the FuNctioN (Fn), select button the function is performed
by sequentially rotating the control n-coder i, setting the function parameter
by means of the control n-coder ii by pressing the control n-coder.
pulse double pulse manual
N-coder ii N-coder i synergic
FuNctioN button
Mig/MAg - Setting the SoFT START function
(approach speed / inlet of wire)
the function is used to start the welding process smoothly and eliminates
the initial spatter of metal when the arc is ignited. the function is activated
by pressing the FuNctioN button (Fn), the function is selected by rotating
the control n-coder i in sequence, the function parameter is set by pressing
the control n-coder ii.
pulse double pulse manual
N-coder ii N-coder i synergic
FuNctioN button
Mig/MAg - Setting the buRn bAcK function
Function to prevent the wire from sticking to the weld. When welding is com -
plete, the wire feeder stops but the arc is still burning for some time. acti -
vation is performed by pressing the FuNctioN button (Fn), the function is
selected by rotating the control n-coder i sequentially, the function parameter
is set by pressing the control n-coder ii.
pulse double pulse manual
N-coder ii N-coder i synergic
FuNctioN button
Mig/MAg - Setting the PoST-gAS function
this function ensures the protection of the weld after the welding process.
the function is activated by pressing the FuNctioN button (Fn), the function
is selected by rotating the control n-coder i in sequence, the function parame -
ter is set by pressing the control n-coder ii.
pulse double pulse manual
N-coder ii N-coder i synergic
FuNctioN button
Mig/MAg - Setting the inDucTAnce function
the function affects the arc burning characteristics. the function is only
active in maNual and syNerGic modes. press the n-coder i in turn to
switch to this function. turning the n-coder i clockwise will soften the arc,
reduce metal spatter, and increase arc length. turning the control n-coder i
counterclockwise causes hardening of the arc, increased metal spatter and
decreases the arc length.