- 31 -
The 3-point linkage with hydraulic lift cylinders (V) reduces the overhang of a combination (
EL 142
- seeder, for
example) by lifting back the combined machine over the
EL 142
(see photo 45 on page 33).
a) Assembly :
The hydraulic lift linkage is fitted to the
EL 142
by means of axle (Q) and pins (U) (photo 43). A spacer washer
(Ø 20 x 45 x 8) must be added on each side of the headstock mounting plates in order to minimise the lateral play
at (U).
Hydraulic cylinders (V) necessitate at least one single acting valve on the tractor.
Attach hydraulic hoses (K) to cross bar by means of 2 hose clamps (N) and connect hoses to the cylinders (V)
as shown in photo 43.
To allow adaptation of Category 1 and Category 2 implements, hooks (A) and spacers (B) can be assembled in
different ways : either to the inside or to the outside of rear frame (C) to obtain desired span.
The hooks (A) can also be adjusted in height (two positions). The locks (D) are used to secure the secondary
implement's lower link pins inside hooks (A) (photo 43 and fig. 44 on page 30).
7)
3-POINT LINKAGE WITH HYDRAULIC LIFT FOR ADDITIONAL IMPLEMENTS
(photo 43)
Kit no. 121 6720
43
