- 35 -
12) P.T.O. SHAFTS
The PTO shaft is available in the following versions to fit the tractor PTO :
- W 2500 1”3/8, 6 splines
:
Part no. 4600 502
- W 2500 1”3/8, 21 splines
:
Part no. 4600 504
- W 2500 1”3/4, 6 splines
:
Part no. 4600 506
- W 2500 1”3/4, 20 splines
:
Part no. 4600 508
11) NYLON CLEANING PLATES FOR STANDARD PACKER ROLLER,
PACKER ROLLER PK2 AND MAXIPACKER ROLLER SCRAPERS
Part No. 525 702 00 for the standard packer roller and the packer roller PK2
Part no. 525 923 00 for the maxipacker roller
These cleaning plates are made from a supple synthetic
material which enables them to be slightly pre
compressed against the roller for improved cleaning
action.
a) Installation and adjustment
(photo 46) :
The nylon cleaning craper plates (R) are to be placed :
- between two new standard steel scraper plates (S)
(525 321 30) for standard and PK2 packer rollers by
using a longer screw (V) (part No 500 073 00),
- between two non hardcoated steel scraper plates (S)
(525 989 10) on maxipacker rollers by using a longer
screw (V) (part No 800 312 40).
46
13) ROTORS COMPLETE
Standard diameter Power Tiller rotor
:
Kit no. 121 6810 for 2.50 m / 8’2"
Kit no. 121 6820 for 3.00 m / 9’10"
Larger diameter Power Tiller rotor
:
Kit no. 121 6970 for 2.50 m / 8’2"
Kit no. 121 6980 for 3.00 m / 9’10"
CULTITILLER rotor
:
Kit no. 120 6830 for 2.50 m / 8’2"
Kit no. 120 6840 for 3.00 m / 9’10"
CULTIPLOW rotor with 2 bolts per blade
: Kit no. 120 6850 for 2.50 m / 8’2"
Kit no. 120 6860 for 3.00 m / 9’10"
CULTIPLOW rotor with 1 bolt per blade
: Kit no. 120 7010 for 2.50 m / 8’2"
Kit no. 120 7020 for 3.00 m / 9’10"
Allow the nylon cleaning plate (R) to stick out of the carrier plates (S) by 10 mm and press it slightly against the
roller so that its leading edge is in contact with the roller segment across its full width. Rotate the roller one complete
turn to check that there is no gap between roller and nylon cleaning plate. Re-adjust the plate if this is not the case.
Also check that the upper carrier plate is set parallel to the roller segment and does not come into contact with it.
b) Use
:
The nylon cleaning plate is particularly recommended for light, loamy or chalky grounds with little crop residue or
stones. A correct cleaning plate adjustment results in a clean and shiny roller area across the full width of the
cleaning plates.
Soil deposit on the roller will result in premature cleaning plate wear. Readjust them quickly. The cleaning plate
is reversible for increased service life.
