- 29 -
5) REAR WHEEL KIT
(photos 39 and 40)
Kit no. 121 6360 for EL 142 - 2.50 m
Kit no. 121 6370 for EL 142 - 3.00 m
Rear wheels can be fitted in place of the roller for certain surface operations (for example, stubble clearing or
turning over pastures).
The rear wheel kit can be fitted in various positions (lengthways) on the roller arms (P) delivered with the kit by
means of 8 hexagon bolts (H) (M 16 x 55) and 8 self-locking nuts (M 16).
Next fit cross bar (Q) on the fixed arms (U) of the rear wheels using 2 hexagon bolts (V) (M 16 x 55), 2 hexagon
bolts (W) (M 16 x 55), 2 flat washers (X) (diameter 16 x 30 x 3) and 4 self-locking nuts (M 16). The cross bar can
be fitted either in the upper position (as shown on photos 39 and 40) or the lower position (when working with an
integrated seeder or separate seeding system). When fitting in the lower position use the 2 longer hexagon bolts
(W) (M 16 x 80) supplied.
Rear wheels (Y) should face inside the machine for transport to reduce machine width (photo 39). They should
face outside during work so as not to roll over the ground worked by the rotor (photo 40).
It may, however, be useful to work on field edges with the wheels in their transport position. In this case the wheel
scraper should be pivoted to the rear of the machine (seen in the forward direction).
To put the rear wheels into their transport position (photo 39) or work position (photo 40), pivot them inside or out
on vertical axle (F). Lock them in place using linchpin (Z), do not forget to insert washer (R) (diameter
23 x 54 x 6).
40
39
