Kugelmann K-BASIC 2, Original Operating Instructions

Page: 14 / 54

// ORIGINAL OPERATING INSTRUCTIONS
General description 25.04.2019 14/54
5.4 Setup menu
1 screw 2 screws Description
Installed software version.
Regulation equipment of the device (see Chapter
7.3 "Regulation equipment",
page 26
).
Adjustment of drive signal (see Chapter
7.4 "Configuration of drive signal",
page 26
).
Setting of simulated speed (see Chapter
7.5 "Simulation speed", page 28
).
Check sensors (see Chapter
7.6 "Checking and setting of sensors", page 28
).
Recording characteristic curve of spreading disc (see Chapter 7.7 "Regulator
adjustment", page 30 ).
Recording characteristic curve of conveyor screw(s) (see Chapter 7.7 "Regulator
adjustment", page 30 ).
Checking of spread quantity (see Chapter 7.8 "Weighing of spreading materials",
page 31 ).
Fine correction of spread quantity (see Chapter
7.8 "Weighing of spreading
materials", page 31
).
Number of metering screws (see Chapter 7.9 "Number of screws", page 33 ).
Fine correction of spreading width (see Chapter
7.10 "Configuration of spreading
width", page 33
).
Stop of spreading disc in case of vehicle stop (see Chapter
7.11 "Stop of spreading
disc when vehicle stops", page 35
).
Stop of spreading disc in case of pause (see Chapter
7.12 "Stop of spreading disc
at pause", page 35
).
Electrical monitoring of spreading process (see Chapter
7.13 "Electrical monitoring
of spreading process", page 36
).
Rotating beacon (see Chapter
7.14 "Rotating beacon", page 36
).
Working headlight (see Chapter
7.15 "Working headlight", page 37
).
Possibility to record and assemble a spreading protocol (see Chapter
7.16
"Spreading protocol", page 37
).
Increased spreading output when starting (see Chapter
7.17 "Boost function",
page 38
).
Time of increased spreading output when starting (see Chapter
7.17 "Boost
function", page 38
).
Quantity of spreading material in the set time (see Chapter
7.17 "Boost function",
page 38
).
Reset to standard settings (see Chapter
7.18 "Reset to factory settings",
page 39
).
Update (see Chapter
8.2 "Update", page 44
).