Kugelmann Maschinenbau DUPLEX INOX, Operating Instructions Manual

Page: 39 / 50

Spreading pattern adjustment
Kugelmann offers a mechanical and electrical adjustment of the spreading pattern.
With the mechanical adjustment of the spreading pattern, the spreading disc can be moved back and forth by
means of the hand wheel. The more the spreading material is transported to the center, the more the
spreading image is adjusted to the left.
The electrical adjustment of the spreading pattern is executed via the control system k-tronic.
Switch on k-tronic press middle turning knob and turn to the left or to the right, the arrow on the
display moves to the left or to the right correspondingly Press button on the top right Start
If the arrow on the display is located left from the center, the spreading image shifts to the left
correspondingly. Similarly, the spreading image shifts to the right side if the arrow on the display can be seen
right from the center.
Manual operation via flow divider block
By means of the flow divider block, it is possible to operate the spreader manually in case of emergency.
For safety reasons, remove the spreader for the operation of the flow divider block. Set the rear support legs
to parking position, see Chapter 4. After the settings have been made for the hand wheels at the flow divider
block, refit the spreader. Turn over the support legs.
Do not execute any work between the spreader and the carrier vehicle! Remove spreader!
The starting position of the three hand wheels (with option brine four hand wheels) is always zero; otherwise,
the electrical control system would be overlaid by the mechanical control.
Setting of the screw speed of the right-hand chamber by means of the left, black hand wheel (see images next page).
Similarly, the other half of the spreading chamber is set with the right hand wheel. The middle hand wheel
moves the spreading disc in manual emergency operation. With the option brine tanks, another hand wheel
is placed on the far left.
To have malfunctions rectified at the conveyor screws, please proceed as follows: By opening it a bit, start
movement of respective conveyor screw via the hand wheel. Press push-button to reverse the screw (see
image on next page) at the slave to change the direction of rotation of the conveyor screw. This requires
utmost caution. First, check whether the chute is free.
At the control system MCSS 3/4, the conveyor screw is reversed via a toggle switch. The rotating beacon
must be switched on.
Subject to modifications
Chapter 05_
39
www.kugelmann.com