Kugelmann Maschinenbau DUPLEX INOX, Operating Instructions Manual

Page: 37 / 50

Sometimes, the spreading image depends a lot on the quality of the spreading material.
If the height of the spreading disc changes, also spreading width and spreading image change.
This can be caused e.g. by bigger wheels or a higher flatbed.
Adjustment of quantity to be spread
By means of the hand wheel for the adjustment of the spreading pattern, the spreading disc must be
adjusted via the spindle completely to the back.
With electrical adjustment of spreading pattern, the
spreading disc is brought into this position by means of the control system k-tronic.
Switch on the k-tronic press button at bottom left and hold it pressed press button at bottom right
Emptying appears, release buttons push button at bottom right Adjustment of spreading
position automatically reaches maximum position Exit menu
Do not reach into the metering screws
-
danger of severe injury
.
Place an empty bucket with a capacity of at least 30 liters below the respective outlet of the metering screws.
Furthermore, a scale is necessary to weigh the spread quantity of salt exactly.
Remove the brine hose from the spreading disc and hold it into a separate collecting vessel (bucket).
Proceed analogously to the procedure described for the conveyor screw.
The spreading rate must be set for each outlet and for each used spreading material. The conveyor screws
must be filled completely with spreading material. With manual operation, move the conveyor screws via the
flow divider block until spreading material is drawn evenly. Empty the bucket and position it.
The adjustment of the spreading material is described in the detailed description “Control system k-
tronic for the distributor”.
Timing chart overview
On the k-Tronic Details menu Spreading materials Salt, grit or brine
Subject to modifications
Chapter 05_
37
www.kugelmann.com