Kubota M6H-101, Operator'S Manual, Page: 107 / 202

3. PTO rpm display
The PTO rpm can be checked on the LCD monitor.
(1) PTO rpm
NOTE :
• When the PTO speed is changed from 540 rpm
to 1000 rpm, it is necessary to switch the PTO
speed display mode. Otherwise, the PTO speed
will not be correctly displayed on the LCD
monitor. Such mode switching is also needed
when returning to the 540 rpm PTO speed.
(See Setting the PTO speed display on page 91.)
4. 1000 rpm PTO shaft (if equipped)
WARNING
To avoid personal injury or death:
• Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
By interchanging the PTO shafts, 2 different PTO shaft
speeds can be obtained.
(1) PTO shaft
(2) Snap ring (A) 540 rpm PTO shaft
(B) 1000 rpm PTO shaft
PTO shaft interchanging procedure
1. The 6-spline 540 rpm PTO shaft is standard
equipment.
2. Place an oil pan under the PTO shaft to catch oil
spillage. Remove the snap ring, and then the PTO
shaft.
3. Install the 21-spline PTO shaft (1000 rpm). To
ensure that it is tight, push it in by turning.
4. Reinsert the snap ring.
PTO OPERATION PTO
M6S-111,M6L-111,M6H-101
101