Kubota M6H-101, Operator'S Manual

Page: 108 / 202

5. Set the distance from drawbar pin hole to the rear
end of PTO shaft according to the following
instructions.
IMPORTANT :
• For maximum PTO shaft speeds of various
implements, see the implement operator's
manual.
Engine speed rpm PTO speed rpm
540 rpm PTO shaft 2405 540
1000 rpm PTO
shaft
2389 1000
PTO PTO shaft type Distance Drawbar
540 rpm 6-spline
355 mm
(14 in.)
B hole
1000 rpm 21-spline
406 mm
(16 in.)
A hole
(1) Drawbar (D) “DISTANCE”
5. PTO shaft cover and shaft cap
Keep the PTO shaft cover in place at all times.
Put back the PTO shaft cap when the PTO is not in
use.
Before connecting or disconnecting a drive shaft to
PTO shaft, be sure engine is
“OFF” . Raise up the PTO
shaft cover.
Afterward, be sure to return the PTO shaft cover to the
“NORMAL POSITION” .
M6S-111 and M6L-111: adjustable shaft cover
(1) PTO shaft cover
(2) PTO shaft cap (A) “NORMAL POSITION”
(B) “RAISED POSITION”
M6H-101: fixed shaft cover
(1) PTO shaft cover
(2) PTO shaft cap
IMPORTANT :
• The universal joint of the PTO drive shaft is
technically limited in its moving angle. Refer to
the PTO drive shaft instructions for proper use.
PTO PTO OPERATION
102
M6S-111,M6L-111,M6H-101