Kubota M6H-101, Operator'S Manual, Page: 124 / 202

should not be longer than 1840 mm
(72.4 in.).
• When using the maximum front tread (2040
mm / 80.3 in.) on 2WD models, there should
not be more than 10 front end weight pieces.
• The front tread width for the front loader
application on 2WD models should not be
greater than 1640 mm (64.6 in.).
2. Front wheels-4WD
Front tread width can be adjusted, as shown, with the
standard equipped tires.
To change the tread width:
1. Remove the wheel rim and disc mounting bolts.
2. Change the position of the rim and disc (right and
left) to the desired position, and tighten the bolts.
3. Adjust the toe-in as 2 to 8 mm (0.1 to 0.3 in.).
(See Adjusting toe-in on page 162.)
IMPORTANT :
• Always attach wheels as shown in the
drawing.
• If not attached as illustrated, transmission
parts may be damaged.
• When re-fitting or adjusting a wheel, tighten
the bolts to the following torques then
recheck after driving the tractor 200 m (200
yards) and 10 times of shuttle movement by
5 m (5 yards), and thereafter according to
service interval.
(See MAINTENANCE on page 137.)
(1) 260 to 304 N ⋅ m / 26.5 to 31 kgf ⋅ m / 192 to 224 ft ⋅ lbs
(2) Except waffle wheel
244 N ⋅ m / 24.9 kgf ⋅ m / 180 ft ⋅ lbs
Waffle wheel
298 to 366 N
⋅ m / 30.4 to 37.3 kgf ⋅ m / 220 to 270 ft ⋅ lbs
NOTE :
• Wheels with beveled or tapered holes: Use
the tapered side of lug nut.
13.6-24
13.6R24
12.4-24
1580 mm
(62.2 in.)
*1
1680 mm
(66.1 in.)
*2
(1) Tread
*1 It is necessary to limit turning angle to 42 degrees. Refer to the
chart provided for additional instructions.
*2 When front loader is equipped.
2.1 Front jack point
WARNING
To avoid personal injury or death:
• Before jacking up the tractor, park it on a firm
and level ground and chock the rear wheels.
• Fix the front axle to keep it from pivoting.
• Select jacks that withstand the machine weight
and set them up as follows.
(1) Jack point
3. Adjusting front wheel turning
stopper bolt
IMPORTANT :
• Always check if tires are in contact with tractor
or loader frame assemblies.
• Adjust turning angle with the provided stoppers
if necessary.
TIRES, WHEELS, AND BALLAST (M6S-111) WHEEL ADJUSTMENT
118
M6S-111,M6L-111,M6H-101