Kubota M5040, Workshop Manual

Page: 414 / 559

8-S16
M5040, M6040, M7040, WSM HYDRAULIC SYSTEM
(2) Removing 3-point Hitch Hydraulic Block (CABIN Model)
Preparation
1. Park the tractor on a flat place.
2. Place the disassembling stand under the transmission case and
rear axle.
3. Remove the rear wheel (R.H.).
4. Remove the lift rods (1).
5. Disconnect the cylinder hoses (5), (7) and return hose (6).
6. Draw out the pins (2), (3) and remove the cylinder (4).
7. Remove the auxiliary control valve wire (8).
8. Remove the 3-point hitch delivery pipe (9).
9. Disconnect the position control rod (10) and draft control rod (11).
NOTE
Q
• Take care not to damage the grease nipple when remove the
hydraulic cylinder pin.
(When reassembling)
• Apply grease to the grease nipples.
• Take care not to damage the grease nipples when reassemble
the hydraulic cylinder.
• To assemble the auxiliary control valve wire, refer to “4.
CHECKING AND ADJUSTING” in this section.
• Be sure to fit the O-rings for auxiliary control valve.
• Be sure to adjust the position control rod and draft control rod.
W1076845
Tightening torque
Rear wheel mounting nut
260 to 304 N·m
26.5 to 31.0 kgf·m
191.8 to 224.2 lbf·ft
3-point hitch delivery pipe
retaining nut
107.9 to 117.7 N·m
11.0 to 12.0 kgf·m
79.6 to 86.8 lbf·ft
Cylinder hose retaining nut
45.1 to 53.0 N·m
4.6 to 5.4 kgf·m
33.3 to 39.1 lbf·ft
Position control rod
length (
L1 )
Factory spec.
Approx. 185 mm
7.28 in.
Draft control rod length
(
L2 )
Factory spec.
Approx. 182 mm
7.17 in.
(1) Lift Rod
(2) Pin (Upper)
(3) Pin (Lower)
(4) Hydraulic Cylinder
(5) Cylinder Hose (R.H.)
(6) Return Hose
(7) Cylinder Hose (L.H.) (8) Auxiliary Control Valve Wire
(9) 3-point Hitch Delivery Pipe
(10) Position Control Rod
(11) Draft Control Rod
L1 : Position Control Rod Length
L2 : Draft Control Rod Length
KiSC issued 06, 2008 A