Kubota M5040, Workshop Manual

Page: 101 / 559

G-79
M5040, M6040, M7040, WSM G GENERAL
[3] WHEEL HUB
W1043392
[4] TIRE PRESSURE
CAUTION
• Do not attempt mount a tire. This should be done by a qualified person with the proper equipment.
IMPORTANT
Q
• Excessive wear of tires may occur due to improper gear ratio.
Through the tire pressure is factory-set to the prescribed level, it
naturally drops slowly in the course of time. Thus, check it every day
and inflate as necessary.
Q
Recommended Inflation Pressure
• Maintain the pressure shown below for normal use.
NOTE
Q
• Maintain the maximum pressure in front tires, if using a front
loader of when equipped with lots of front weight.
W1027488
Front wheel hub Rear wheel hub
2WD 4WD –
Screw circle diameter
(A)
152.4 mm
(6 in.)
203.2 mm
(8 in.)
203.2 mm
(8 in.)
Number of screws 6 8 8
Screws M14
×
P1.5 M16
×
P1.5 M16
×
P1.5
Hub pilot diameter (B)
114.0 mm
(4.488 in.)
152.4 mm
(6 in.)
152.4 mm
(6 in.)
Tire sizes Inflation pressure
Front
6.50-16, 6PR 320 kPa (3.2 kgf/cm
2
, 46 psi)
7.50-16, 6PR 280 kPa (2.8 kgf/cm
2
, 40 psi)
9.5L-15, 6PR 220 kPa (2.2 kgf/cm
2
, 32 psi)
9.5-20, 6PR 200 kPa (2.0 kgf/cm
2
, 29 psi)
9.5-22, 6PR 200 kPa (2.0 kgf/cm
2
, 29 psi)
9.5-24, 6PR 180 kPa (1.8 kgf/cm
2
, 26 psi)
Rear
14.9-28, 6PR 140 kPa (1.4 kgf/cm
2
, 20 psi)
16.9-28, 6PR 120 kPa (1.2 kgf/cm
2
, 18 psi)
16.9-30, 6PR 120 kPa (1.2 kgf/cm
2
, 18 psi)
(A) Insufficient
(B) Standard (C) Excessive
(D) Ground
KiSC issued 06, 2008 A