Kubota M5040, Workshop Manual

Page: 290 / 559

3-S37
M5040, M6040, M7040, WSM TRANSMISSION
PTO Shaft and Bearing Holder
1. Draw out the PTO shaft (1) with 33T gear (3).
2. Remove the bearing holder mounting screws.
3. Screw in a M12 x 1.25 mm screw (4) into threaded hole
(a) to
remove the bearing holder (2).
4. Remove the bearing holder (2).
W1021915
1st Shaft, 2nd Shaft and 3rd Shaft
1. Slowly draw out the three shafts with gears together.
2. Take out the three shafts from clutch housing case.
IMPORTANT
Q
• Do not fall down the shaft when removing the shafts with
gears.
• Do not tap the bearing stop part (a) of clutch housing case,
it cause break a part of clutch housing case. Be sure to tap
at the inner race of bearing (4) or 2nd shaft when remove the
2nd shaft assembly (2).
W1022258
(1) PTO Shaft
(2) Bearing Holder
(3) 33T Gear
(4) M12 x 1.25 mm Screw (a) Threaded Hole
(1) 1st Shaft Assembly
(2) 2nd Shaft Assembly
(3) 3rd Shaft Assembly
(4) Bearing a : Bearing Stop Part
KiSC issued 06, 2008 A