2-S18
GL6000, GL7000, GL9000, GL11000, WSM
GENERATOR
(2) Generator
Rear Bracket
1. Remove the rear bracket mounting nuts.
2. Disconnect the wire harness and the carbon brushes, etc.
3. Lift up the generator.
4. Remove the rear bracket (1).
(When reassembling)
• Clean dirt from the bearing housing.
• When installing the bearing, make sure the relative positioning
between the snap ring and outer ring is correct.
Follow the point below.
• Be certain that the center of the bulge of the snap ring is in the
bottom of the eccentric groove of the outer ring (there is a mark
on the outer ring's outside surface). Now put the NCX bearing in
its housing. Be careful to position the bearing correctly.
Misalignment may make it difficult to install the bearing or what's
worse, damage it.
IMPORTANT
• Be careful not to confuse the direction of the snap ring of the
bearing.
[GL6000, GL7000]
[GL9000, GL11000]
W1030949
Stator Assembly and Stator Housing
1. Hoist up the stator assembly (1).
2. Remove the stator assembly (1), take care not to damage the
winding and the rotor.
3. Remove the stator housing (2).
(When reassembling)
• Do the set-up in the original position (direction).
W1031068
Tightening torque
Stator mounting screw
5.9 to 8.8 N·m
0.6 to 0.9 kgf·m
4.4 to 6.5 lbf·ft
Tightening torque
Stator mounting screw
18 to 22 N·m
1.9 to 2.2 kgf·m
14 to 16 lbf·ft
(1) Rear Bracket
(a) Direction of rotation
(b) Snap ring
(c) Bottom of the eccentric groove
(d) Wedge place
(1) Stator Assembly
(2) Stator Housing
KiSC issued 05, 2015 A