KTR Kupplungstechnik
GmbH
D-48407 Rheine
R O T E X
®
m o u n t i n g
i n s t r u c t i o n s
d e s i g n Z S - D K M a n d Z S - D K M - H
KTR-N
sheet:
edition:
40224 E
9
4
Gezeichnet:
14.07.06 Sha/At
Ersatz für:
Schutzvermerk
ISO 16016 beachten. Geprüft:
07.08.06 Sha
Ersetzt durch:
4 Assembly
4.1 Components of Couplings
Components of ZS-DKM-H
component quantity
designation
component quantity
designation
5 2
1)
cap screws
DIN EN ISO 4762
1Dh 2
clamping hub DH with half
length taper-grooved dowel pin
DIN EN ISO 874 (2 pieces)
6x 2
DKM-H-middle
piece
2 2
spider
1) each clamping hub DH
picture 6: ROTEX
®
, design ZS-DKM-H
Features of the standard spiders
spider hardness
(Shore)
marking
(colour)
95/98 Sh A
red
4.2 Hint Regarding the Finish Bore
STOP
D A N G E R !
The maximum permissible bore diameters d (see
table 1 to 3 in chapter 1 - Technical Data) must not be
exceeded. If these figures are disregarded, the coupling
may tear. Rotating particles may cause serious danger.
•
Hub bores machined by the customer have to observe
concentric running or axial running, respectively (see
picture 7).
•
Please make absolutely sure to observe the figures for
d
max
.
•
Carefully align the hubs when the finish bores are
brought in.
•
Only applying with design ZS-DKM1 and ZS-DKM3:
Please use a set screw or an end plate to axially fasten
the hubs.
picture 7: concentric running
and axial running