IMPORTANT INFORMATION
5
Use definition
KTM sport motorcycles are designed and built to withstand the normal stresses and strains of competitive use. The motorcycles com-
ply with currently valid regulations and categories of the top international motorsport organizations.
Info
The motorcycle must be used only in closed off areas remote from public road traffic.
Maintenance
A prerequisite for perfect operation and prevention of wear is that the engine and chassis maintenance and adjustment work described
in the owner's manual are properly carried out. Poor adjustment and tuning of the engine and chassis can lead to damage and break-
age of components.
Using the motorcycle in difficult conditions such as on sand or very muddy or wet terrain can lead to above-average wear of compo-
nents such as the transmission train or the brakes. For this reason, it may be necessary to service or replace worn parts before the
limit specified in the service schedule is reached.
Pay careful attention to the prescribed running-in period, inspection and maintenance intervals. If you observe these exactly, you will
ensure a much longer service life for your motorcycle.
Warranty
The work prescribed in the service schedule must be carried out in an authorized KTM workshop only and confirmed in the customer's
service record, since otherwise no warranty claims will be honored. No warranty claims can be honored for damage resulting from
manipulations and/or alterations to the vehicle.
Fuel, oils, etc.
You should use the fuels, oils and greases according to specifications as listed in the owner's manual.
Spare parts, accessories
For your own safety, only use spare parts and accessory products that have been approved and/or recommended by KTM and have
them installed by an authorized KTM workshop. KTM accepts no liability for other products and any resulting damage or loss.
Certain spare parts and accessories are specified in parentheses in the descriptions. Your KTM dealer will be glad to advise you.
The current
KTM PowerParts
for your vehicle can be found on the KTM website.
International KTM Website: http://www.ktm.com
Work rules
Special tools are needed for certain tasks. They are not included with the vehicle but can be ordered under the number in parenthe-
ses. Ex.: bearing puller (15112017000)
During assembly, non-reusable parts (e.g. self-locking screws and nuts, seals, seal rings, O-rings, pins, lock washers) must be replaced
by new parts.
If a thread locker is used for the screw connections (e.g.
Loctite
®
), follow the specific manufacturer instructions regarding its use.
Parts that are to be reused after disassembly must be cleaned and checked for damage and wear. Change damaged or worn parts.
After repair and maintenance, ensure that the vehicle is roadworthy.
Transport
Note
Danger of damage
The parked vehicle can roll away or fall over.
–
Always place the vehicle on a firm and even surface.
Note
Fire hazard
Some vehicle components get very hot when the machine is driven.
–
Do not place the vehicle where there are flammable or explosive substances. Do not place objects over the vehicle while it is still
warm from being run. Always let the vehicle cool first.
–
Switch off the engine.
–
Use straps or other suitable devices to secure the motorcycle against accidents or falling over.
Summary of Contents for 50 SX MINI 2010
Page 1: ...OWNER S MANUAL 2010 50 SX 50 SX Mini Art no 3211477en ...
Page 2: ......
