KTM 350 EXC-F 2015, Owner'S Manual

Page: 85 / 122

15 ELECTRICAL SYSTEM
83
15.1 Removing the battery
x
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. ( p. 56)
–
Remove the air filter box lid. ( p. 57)
M00232-10
Main work
–
Disconnect negative cable

from the battery.
–
Pull back positive terminal cover

and disconnect the positive cable from the
battery.
–
Detach rubber band

at the bottom.
–
Lift the battery up and out.
15.2 Installing the battery
x
M00233-10
Main work
–
Insert the battery into the battery compartment with the terminals facing forward.
Battery (YTX4L-BS) ( p. 109)
–
Reconnect rubber band

.
–
Position the positive cable

and mount and tighten the screw.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
Info
Contact disk

must be mounted between screw

and cable lug

with the claws facing down.
–
Slide positive terminal cover

over the positive terminal.
–
Position the negative cable  and mount and tighten the screw.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
Info
Contact disk

must be mounted between screw

and cable lug

with the claws facing down.
Finishing work
–
Install the air filter box lid. ( p. 57)
–
Mount the seat. ( p. 56)