18
SERVICE WORK ON THE ENGINE
97
The engine oil is at a level between the lower edge
and the upper
edge
of the level viewer.
» If the engine oil is not up to the lower edge
of the level viewer:
–
Add engine oil. (
18.3
Changing the engine oil and oil filter, cleaning the oil screen
x
Warning
Danger of scalding
Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
Preparatory work
–
Park the motorcycle on a level surface.
M00199-10
Main work
–
Place a suitable container under the engine.
–
Remove oil drain plug
with the magnet and seal ring.
Info
Do not remove screws
on both sides.
M00200-10
–
Remove screw plug
with oil screen
and the O-rings.
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
M00201-10
–
Position oil screen
with the O-rings on a pin wrench.
–
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
–
Push the oil screen all the way into the engine case.
M00202-10
–
Mount and tighten screw plug
with the O-ring.
Guideline
Screw plug, oil screen
M20x1.5
15 Nm
(11.1 lbf ft)
–
Mount and tighten the oil drain plug
with the magnet and a new seal ring.
Guideline
Oil drain plug with magnet
M12x1.5
20 Nm
(14.8 lbf ft)
Summary of Contents for 350 EXC-F 2015
Page 1: ...OWNER S MANUAL 2015 350 EXC F US Art no 3213182en ...
Page 2: ......