KTI KS-2300, User Manual

Page: 34 / 85

28
before you delete an entry in the routing table. Therefore, be sure you
want to delete the entry before doing so.
- Highlight the Routing table entry you want to delete and press "-". The
entry will be deleted.
3). Searching for Routing Table Entries
To search for entries in the Routing table, press S in the Routing Table
screen. Then "Enter Network Address" screen appears. Type the
network address you want to search for, then press Enter.
Note: You can assign the gateway IP address of the switch with the
“Default Gateway” in Adding Routing Table Entries operation for
management through Internet.
u
DHCP Gateway Setting :
If you highlight DHCP Gateway Settings from the "IP Networking" screen
and press the Enter key, a DHCP Gateway Settings screen appears.
In this screen:
- VLAN ID shows the IDs of the VLANs that have been defined.
- IP Address shows the corresponding IP addresses of the VLANs.
- DHCP Relay shows whether the DHCP relay is enabled or disabled.
- Max Hops shows the maximum number of hops that a DHCP request
broadcast can be relayed along the DHCP relay path from the DHCP client
to the DHCP server.
- Delay shows the number of seconds that must elapse before a DHCP
request broadcast is relayed to the next IP subnetwork.
- Servers shows any preferred servers that have been defined.
- Relays shows the outbound IP subnetwork for relaying a DHCP request
broadcast.
Notes: To specify DHCP gateway settings, you must first create a VLAN
with an assigned IP address as described in " VLAN Perspective " of " L2
Switching DataBase ".
The following procedure describes how to change the DHCP gateway
settings. As part of this procedure, you can specify up to three preferred
servers and/or an outbound relay interface.