User Manual for OMNI-IP Network Cameras
3
Safety Instructions
These instructions are intended to ensure that the camera is installed in a manner that
avoids danger to persons or property loss.
These precautionary measures are divided into “Warnings” and “Cautions”
Warnings:
Serious injury or death may occur if any of the warnings are neglected.
Cautions:
Injury or equipment/property damage may occur if any of the cautions are
neglected.
Warnings
Follow these safeguards to
prevent serious injury or death.
Cautions
Follow these precautions to
prevent potential injury or material
damage.
Warnings:
In the use of the product, you must be in strict compliance with the electrical
safety regulations of the nation and region. Please refer to technical specifications
for detailed information.
Input voltage should meet the requirements for both the SELV (Safety Extra Low
Voltage) and Limited Power Source for 12 VDC according to the IEC60950-1
standard; or 802.3af PoE. Please refer to technical specifications for detailed
information.
If connecting several devices to one power supply, to avoid any overload that may
cause over-heating or a fire hazard insure that the power supply is adequate for the
power load.
Please make sure that all plugs are firmly connected to the power sockets. When
the product is mounted on wall or ceiling, the device shall be firmly attached,
taking into consideration any wind, snow loading, or other factors. The mounting
surface shall be capable of supporting several times the base weight of the camera.
If smoke, unusual odors or noise come from the device, turn off the power at once
and unplug the power cable, and then contact authorized service personnel.
If the product does not work properly, please contact your dealer or the nearest
service center. Never attempt to disassemble the camera yourself. (We shall not
assume any responsibility for problems caused by unauthorized repair or
maintenance.)
To reduce the risk of fire or electrical shock, do not expose this product to rain or
