User Manual for OMNI-IP Network Cameras
4
moisture beyond the IP66 rating of applicable products.
Installation should be performed only by qualified service personnel and should
conform to all local codes.
Please install appropriate overload protection in the power supply circuits for any
necessary power supply interruption.
Please make sure that the wall/ceiling can support more than three times the
weight of the camera (and any other forces such as wind or snow loading) if the
camera is mounted to a wall/ceiling.
Cautions:
Make sure the power supply/PoE voltage is correct before using the camera.
Do not drop the camera or subject it to physical shock.
Do not touch lenses or sensor modules with fingers. If cleaning is necessary,
use clean cloth with a bit of ethanol and wipe gently. If the camera will not be
used for an extended period, please protect the lens openings from damage
and/or debris.
Avoid aiming the camera at the sun or extremely bright light sources.
Blooming or smearing may occur in excessive light (which is not a
malfunction), and could compromise the performance of the sensor.
The sensor may be damaged if exposed to laser energy, so when any laser
equipment is in use, make sure that the sensor will not be exposed to the laser
beam.
Do not place the camera in extremely hot or cold (see camera specifications)
locations. Do not exceed the rated environmental (IP66) conditions. Do not
expose the camera to high levels of electromagnetic (RF) radiation.
To avoid heat accumulation, good ventilation is required in the operating
environment.
Keep the camera away from solvents while in use; exposure to liquids should
not exceed IP66 environmental conditions.
During shipping, the camera shall be packed in its original packing, or packing
providing the equivalent protection.
Improper use or replacement of any batteries (if so equipped) may result in the
hazard of explosion. Replace with the same or equivalent type only. Dispose
of used batteries according to the instructions provided by the battery
manufacturer.
If the product does not function properly, Dealers please contact KT&C; End
Users please contact your KT&C Certified Dealer or an authorized service
center. Do not disassemble the camera for repair or maintenance by yourself.
(KT&C shall not assume any responsibility for problems caused by
unauthorized repair or maintenance.)
