KSR Ride Speedy, Repair Manual

Page: 68 / 79

ELECTRICAL SYSTEM/ CABLES 68
• Loose cable is a hidden trouble to electrical safety.
After clamped check each cable to ensure electrical
safety.
• It is not allowed to leave any wire clip bending
towards bonding points.
• Bind each cable to its designated position.
• It is not allowed to lay a cable to end or a sharp
corner on frame.
• It is not allowed to lay a cable to end of a bolt or
screw.
• When laying a cable, keep it away from any heat
source or any place where may bite it when it is
moving.
• When laying a cable along a handle, avoid it being
strained too tightly or loosely and it can not interfere
with any adjacent part at any turning point.
• All cables should be laid smoothly without twist or
knot.
• Before butt-jointing a connector,check if its sheath
has been damaged and if it is overstretched.
• If a cable is at a sharp corner or outer corner, use
tape or hose to protect it.
• After a cable is repaired, use tape to bind it securely.
• Keep all control cables from bend or twist because
dumb control will result in case any control cable is
damaged.
NOTE
O: CORRECT
X: INCORRECT