KSR Ride Speedy, Repair Manual

Page: 30 / 79

BRAKES 30
4
1
2
1
REAR BRAKE PAD WEAR INSPECTION
Reduced braking efficiency caused by worn brake pads.
Change worn brake pads immediately. Always replace the
brake pads in pair.
1. Check the brake pads for minimum thickness.
Allowable limit (A): 3 mm
2. Remove the rear fork cover.
3. Remove the fixing nut (1) of the rear wheel (2).
4. Remove the brake pad (3).
5. If the minimum thickness is less than specified,damage
or cracking is visible change the front brake pads.
6. Reassemble in reverse order.
BRAKE DISC INSPECTION
1. Check the thickness of the front disc at several places
on the disc to see if it conforms to measurement.
Allowable limit (A): 3 mm
2. If the brake disc thickness is less than the specified value
change the brake disk. Check the front disk for damage,
cracking or deformation change the brake disc.
3. Loose the mounting nut (2) which fixing the axle (3) of the
front wheel (4) in order to remove the front wheel and its axle.
4. Place an appropriate supporting stand to raise the front
wheel up.
5. Remove the three screws (5) to remove the front brake disc
(1) and mount a new one if the old one is worn.
6. Reassemble in reverse order.
5 2
2
3