122
ELECTRICAL SYSTEM/ CABLES
NOTE
• Loose cable is a hidden trouble to electrical safety. After
clamped check each cable to ensure electrical safety.
•
It is not allowed to leave any wire clip bending towards bond-
ing points.
•
Bind each cable to its designated position.
•
It is not allowed to lay a cable to end or a sharp corner on
frame.
•
It is not allowed to lay a cable to end of a bolt or screw.
•
When laying a cable, keep it away from any heat source or
any place where may bite it when it is moving.
•
When laying a cable along a handle, avoid it being strained
WRRWLJKWO\RUORRVHO\DQGLWFDQQRWLQWHUIHUHZLWKDQ\DGMDFHQW
part at any turning point.
•
All cables should be laid smoothly without twist or knot.
•
%HIRUHEXWWMRLQWLQJDFRQQHFWRUFKHFNLILWVVKHDWKKDVEHHQ
damaged and if it is overstretched.
•
If a cable is at a sharp corner or outer corner, use tape or hose
to protect it.
•
After a cable is repaired, use tape to bind it securely.
•
Keep all control cables from bend or twist because dumb con-
trol will result in case any control cable is damaged.
O: CORRECT
X: INCORRECT
