7 Servicing/Maintenance
54 of 132
Amacan P
5. Attach the lifting chain or lifting rope with the shackle to the first lifting lug
(together with the crane hook).
6. Unclip the crane hook and attach it to the second lifting lug.
7. Pull the pump set up until it reaches the third lifting lug. Free the lifting chain
or lifting rope from the first lifting lug and attach it to the third lifting lug.
8. Pull the pump set up until it reaches the fourth lifting lug. Unclip the crane
hook and attach it to the fourth lifting lug.
9. Repeat this procedure until the pump bail is located above the discharge tube,
then attach it to the crane hook.
10. Remove the safety cover from the discharge tube.
11. Extract the pump set from the discharge tube, move it sideways and place it
down.
WARNING
Pump set tilting
Risk of squashing hands and feet!
▷
Suspend or support the pump set.
CAUTION
Improper storage
Damage to the power cables!
▷
Support the power cables at the cable entry to prevent permanent
deformation.
▷
Protect the core ends against moisture.
12. To prevent the pump set from tipping over, do not disconnect it from the hook
of the lifting equipment.
13. Clean the pump set (e.g. with water).
14. Collect and properly dispose of any cleaning liquid.
7.3.2 Drainage/cleaning
WARNING
Fluids handled, consumables and supplies which are hot and/or pose a health
hazard
Hazard to persons and the environment!
▷
Collect and properly dispose of flushing fluid and any fluid residues.
▷
Wear safety clothing and a protective mask if required.
▷
Observe all legal regulations on the disposal of fluids posing a health hazard.
1. Always flush the pump if it has been used for handling noxious, explosive, hot
or other hazardous fluids.
2. Always flush and clean the pump before transporting it to the workshop.
Provide a certificate of decontamination for the pump set.
(
ð
Section 11, Page 127)
7.3.3 Checking the cable bundle
When removing the pump set from the discharge tube, check the hoisting rope and
the cables for any damage. Replace any damaged components by original spare
parts.
