n
As soon as the milk begins to move, slowly return the frothing spout back to the surface with a circular
motion. Plunge the spout into the container again this time with an increasing circular movement.
n
Do this several times until the milk turns into a thick and creamy froth.
n
When the required quantity of milk is reached, close the spout circuit by turning the control button to
PENDING
(
●
)
.
n
You can now remove the container from the spout.
Important
- Following the production of steam, the spout and its frothing nozzle are
extremely hot. Be careful of the risk of accidental burns.
- It is strongly recommended that the spout and its frothing nozzle is cleaned
every time milky froth is made (See section "Cleaning and maintenance"
page 20). This operation prevents any risk of spreading micro bacteria.
Important
To change to the ESPRESSO function after the production of steam, it is
imperative that hot water is passesd through the spout (See "Hot water
function" page 17) to force the temperature of the thermo block to fall. The
ESPRESSO function will remain blocked if this operation is not performed
first.
4. DESCALING
Reminder:
The guarantee does not cover faulty appliances on which descaling was not performed
regularly.
Important
If you use your machine on almost a daily basis, regular descaling of the different
water circuits is recommended on average every 2 months
Descaling of the E S PR E S S O circuit
This operation is performed with the filter holder removed.
n
Empty the water tank completely.
n
Pour 500 ml of water into the tank with a sachet of “Special espresso” anti-scale agent available in
stores or 250 ml of white vinegar mixed with 250 ml of water.
n
Place a large container under the dispensing unit.
n
Turn the appliance on and check that the rotating control button is set to PENDING
(
●
) (Fig.4)
and
that the TEMPERATURE SELECTION button (h5) is at ESPRESSO/HOT WATER
. Wait until
the TEMPERATURE light (h6) stops flashing.
a) Activate the pump using the Pre-programmed 1 cup espresso button
or the Pre-programmed
2 cup button
to dispense approximately 50 ml in the container then stop the pump by
releasing the button used.
Important
By doing this, the personal setting for the volume of espresso linked to the
button used is changed.
Remember to reset this when you next make a espresso.
English
19
KR_ESPRESSO-COMBI_XP6040_NAFTA_NC00023128-03 20/01/12 14:46 Page19
