b) Immediately turn the START/STOP (h7) button to
"
●
"
to switch off the machine (this must be
done before the suction noise for draining is triggered).
c) Let the solution rest for approximately 10 minutes in the case of the anti-scale agent (and 20
minutes for the vinegar mixture) to let the liquid act in the heating unit and at the entrance to the
dispensing unit.
n
Repeat steps a) to c) twice.
Descaling of the S P OUT circuit
The descaling of the SPOUT circuit is very similar to that of the ESPRESSO circuit.
n
Place the container under the adjustable spout and position correctly.
n
Turn the appliance on and check that the rotating control button is set to PENDING
(
●
)
and that the
TEMPERATURE SELECTION button (h5) is at EXPRESSO/HOT WATER
.
n
Wait until the TEMPERATURE light (h6) stops flashing.
n
Turn the rotating control button to the right to select the HOT WATER function "
.
n
Let the antiscale agent flow through the spout for a maximum of 20 seconds.
n
Stop the flow by turning the rotating control button to PENDING
(
●
)
.
n
Immediately switch off the machine by turning the START/STOP (h7) button to
●
.
n
Let the solution rest for the same length of time as for the ESPRESSO circuit.
n
During this time, remove the remainder of the anti-scale agent contained in the tank and rinse thoroughly
with fresh water.
Rinsing of circuits
n
Fill the tank with fresh water up to the maximum water level.
n
Turn the machine on and wait until the TEMPERATURE light (h6) stops flashing.
n
Get a large container to collect the water.
n
Start rinsing by circulating a full tank of fresh water as follows:
- 3/4 of the tank through the ESPRESSO circuit
- 1/4 of the tank through the SPOUT circuit
IMPORTANT
Once you have let the equivalent of a tank of fresh water circulate through the 2 circuits you can
be sure that there is no anti-scale agent left in the tank nor any residue taste resulting from its use.
5. CLEANING AND MAINTENANCE
To ensure that your Dual Espresso-Filter Coffee Machine works for many years, we advise that you perform
regular maintenance.
Important
- Before any cleaning, disconnect the machine’s power cord and ensure that the
machine is cold.
- None of the machine’s parts can be put in the dishwasher.
Regular cleaning of filters and filter holder
n
After each use, clean the filter and the filter holder opening under warm water.
n
Regularly check that the sieves at the bottom of the filters are not blocked. If necessary, use a fine
needle (not supplied) to unblock the holes. You can also wipe the upper surface of the sieves using a
synthetic brush and run the filters under warm water to remove any dirt.
English
20
KR_ESPRESSO-COMBI_XP6040_NAFTA_NC00023128-03 20/01/12 14:46 Page20
