Krups XP2240, Manual

Page: 13 / 135

Problems Possible causes Solutions
Cracking are
heard in the filter
holder.
This is normal. It is the filter
holder safety lock.
The pump is
unusually noisy.
No water in the tank.
Tank poorly fitted.
Stop the appliance, fill the water tank and turn
the machine back on.
Press down firmly on the tank.
The cups are not
filled equally.
The filter holder is clogged. See paragraph 4.
The machine leaks
on the sides of the
filter holder.
The filter holder has not been
properly positioned.
The edge of the filter holder is
clogged by ground coffee.
Pod poorly positioned in the
filter. Put the filter holder in place and lock it (by turning
it to the right as far as it will go, up to the stop).
Remove excess coffee.
Place all the paper inside the filter holder.
Your espresso
tastes bad. After descaling, the rinsing
was not performed properly. Rinse the appliance according to the manual
(see paragraph 5).
The appliance
does not work
The pump was unprimed due
to lack of water.
The detachable water tank is
not properly clicked in place.
The Claris cartridge has been
replaced but not primed Fill the water tank and reprime the pump (see
paragraph 1). Avoid completely emptying the tank.
Click the tank into place by pressing firmly.
Refer to section 1 "Using" and "installation of the
Claris cartridge".
The steam nozzle
does not froth the
milk.
The steam nozzle is blocked
or scaled up.
The milk is too hot.
The shape of the container is
not appropriate.
The milk is not fresh enough. Descale the steam nozzle (see paragraph 5) or
unblock it with a needle.
Use cold milk.
Use a small pitcher.
Use very fresh, very cold milk. You may also
need to change your brand of milk.
10
English
IFU_KR_XP2240_EE_NC00026068-01 29/11/11 09:46 Page10