Krups XP2240, Manual

Page: 6 / 135

Français
3
English
n
To prolong the life of your appliance, we recommend you always use a Claris Aqua Filter System
cartridge (reference: F088 which can be ordered via our web site www.krups.co.uk) and that you
descale the appliance at regular intervals.
IMPORTANT!
Before using for the first time, after a prolonged period of inactivity or after desca-
ling, the appliance must be cleaned as described in paragraph 1: "USING".
Before using your espresso machine, clean all the accessories in soapy water and dry them.
If you do not use the Claris cartridge, refer directly to the section "RINSE YOUR AP-
PLIANCE".
A. INSTALLING THE CLARIS CARTRIDGE (to be done every time the cartridge is replaced,
Claris Cartridge can be ordered via our web site www.krups.co.uk)
If you use a Claris cartridge, please apply the following procedure to fill it with water.
n
Screw the Claris filter into the bottom of the water tank.
n
Fill it with water (fig. 2) .
n
Replace the water tank by positioning it firmly, to ensure the water inlet is in place, and close the lid
(fig.3)
n
Turn the appliance on by pressing the "On / Off" button (fig.4) .
n
Turn the switch to the “steam preheating” position. Once the light stops blinking, turn back the switch
to the "off" position. Repeat this operation 4 more times.
To make sure the Claris cartridge is full of water, place a container under the percolation head, turn the
switch to the "coffee" position and make sure some water is running through. If not, repeat the above
procedure.
n
In this manner you can be sure that water is circulating well through the filter cartridge.
IMPORTANT:
This installation procedure must be carried out every time the cartridge is
replaced.
The Claris cartridge needs to be replaced every 2 to 3 months if it is used daily.
B. RINSING YOUR APPLIANCE (to be done on first use and after each cleaning / descaling
operation)
- RINSING OUT THE ESPRESSO CIRCUIT
Then rinse the appliance. To do so:
n
Turn the machine on and fill the water tank
n
Insert the filter holder (without ground coffee) in the appliance (fig.7) .
n
Place a container of sufficient volume under the filter holder.
n
As soon as the appliance reaches the required temperature, the "on/off" light stops flashing. Turn the
switch to the “coffee” position and let all the water run from the water compartment
(fig.8) .
n
If necessary, stop the operation by turning the switch to the "off" position (fig. 9) to empty the
container and then resume the operation.
n
Empty the container and unlock the filter holder: press the "OPEN" button on the filter holder and
turn it to the left
(fig.10) .
1.USING
IFU_KR_XP2240_EE_NC00026068-01 29/11/11 09:46 Page3