Krüger & Matz HD4347, Owner'S Manual

Page: 41 / 88

41
Owner’s manual
English
TUNER OPERATION
The FM tuner built into this unit can hold up to 20 preset stations.
Radio reception requires that appropriate FM antenna be connected to the unit’s rear panel.
1. Press TUNER button to select tuner source.
2. Tune a radio station:
manually:
Press the button on the remote to go to a higher frequency or the TUNING –
button to go to a lower frequency.
automatically:
Hold the or TUNING – button down for about 3 seconds and release it. The
scan will stop when the unit’s tuner finds the next active frequency.
Create Memory Preset
1. Use the /– buttons on the remote control to tune the station you want to set into
memory.
2. Press MEMORY button on the remote twice, the station will be saved.
PTY Search
Press PTY button on remote to search by program type.
APS
(Automatic Program Station) Press APS button to allocate and memorize radio station automatically
TROUBLESHOOTING GUIDE
To determine any problem with your receiver, check the table below first. If the problem remains,
consult your nearest dealer.
Problem Possible cause Suggestion
Amplifier
When listening to the
music in stereo left/
right speakers reversed
Speakers are connected
wrong
Reconnect if necessary
Low hum or buzz
sound
Power cords or lighting
placed near this product
Place this product as far
as possible from lighting or
power leads
Sound is only heard
from one channel
One of the input cords is
disconnected.
The BALANCE control is set
to one side
Connect the input leads and
adjust the BALANCE control
Sound cuts off when
listening to the music or
no sound even though
power is ON
Speaker impedance is less
than prescribed for this unit
After turning off the power
and then turning it on again,
reduce the volume or change
to the correct 8 ohm speakers
Low bass response Speaker polarity (+/-) is
reversed
Check all speakers for correct
polarity